Siemens Reyrolle 7SR46 - Unpacking, Repacking, Returning, and Storing

Unpacking, Repacking, Returning, and Storing
Unpacking a Device
i
i
NOTE
Devices are tested before delivery. The test certificate is a component of the devices.
•
Check the packaging for external transport damage. Damaged packing may indicate that the devices
inside have also sustained damage.
•
Unpack devices carefully; do not use force.
•
To ensure that devices are in perfect mechanical condition, check the devices via a reception control.
•
Check the enclosed accessories against the delivery note to ensure that everything is complete.
•
Keep the packing in case the devices must be stored or transported elsewhere.
•
Return damaged devices to the manufacturer, stating the defect. Use the original packaging or transport
packaging where possible.
•
Check that the mounting fixings are included.
Repacking a Device
•
If you store devices after reception control, they must be packed in appropriate storage packaging.
•
If the device is to be transported, pack it in transport packaging.
•
Enclose the accessories supplied and the test certificate in the package with the device.
Returning a Device
•
To return the device to the Siemens factory or any Siemens location, contact the customer support center
and follow the instructions specified by them.
i
i
NOTE
Do not transport the device when it is activated. Before transportation, ensure that the device is not in the
battery power mode and protective film is inserted between the battery clip and battery.
Fit the battery cover again and screw it to the housing before transportation.
Storing a Device
•
Only store devices on which you have carried out an incoming inspection. The incoming inspection is
described in 1.3 Incoming Inspection .
•
7SR46 device must be stored in rooms, which are clean and dry. Devices or associated replacement
modules must be stored at a temperature of -25°C to +70°C.
•
To retain the battery life during the transportation and storage, Siemens recommends maintaining the
permissible temperature range from -20°C to +45°C.
•
The relative humidity must be at a level where condensed water and ice are prevented from forming.
•
If the device has been in storage for more than 2 years, connect it to an auxiliary voltage for 1 to 2 days.
This action causes the electrolytic capacitors to form on the printed circuit board assemblies again.
Battery Disposal
•
Comply with the relevant national/international regulations when disposing of batteries.
•
The lithium battery contained in the device must be replaced by skilled personnel.
•
Replace the dead batteries immediately and keep them out of reach of unskilled personnel.
1.1
First Steps
1.1 Unpacking, Repacking, Returning, and Storing
14 Reyrolle, Operating, Manual
C53000-B7040-C103-1, Edition 10.2022