Installing Devices
Preparations
NOTE
The installation depth for 1 device is at least 235 mm.
The M4 holes are the holes for the fastening screws of the device.
NOTE
Use a combidrive screwdriver.
For each device, you need 4 M4x20 Pan Phillips SS screws with nut.
DANGER
Danger due to device being improperly screw-fastened
Incomplete and careless screw fitting results in death, severe injury, or considerable material
damage!
²
Ensure that screw-fastening is complete at all intended bolting points. Tighten the screws with the
nuts using a torque of 0.5 Nm to 0.6 Nm.
²
If no assembly opening is present, then cut out the required assembly opening.
²
Produce the holes as shown in the drilling plan.
Fitting Devices
²
Detach the screws of each on-site operation panel.
²
Insert the device in the installation opening. Make sure that the fastening screws of the on-site operation
panels also protrude exactly into the openings.
²
With the M4 screws, bolt down the device at the top and bottom at all 4 bolting points of the device.
²
Check for secure attachment.
²
Fit the top and bottom screws again.
NOTE
While retrofiting with existing CT, user must check device performance along with primary CT.
2.3
Installing the Device
2.3 Installing Devices
Reyrolle, Operating, Manual 25
C53000-B7040-C103-1, Edition 10.2022
To Next Page
Loading...
