Initial Startup
Establishing Readiness for Operation State
It is assumed that you have gone through steps in chapters 1 to 6. Check the connection of the auxiliary
power supply. You can also read the rated voltage range from the name plate.
After successful testing of your voltage source, switch it ON. The device is now powered ON. The HEALTHY
LED (Green) lights up. If the protective film is inserted between the battery and the battery clip, the LOW
BATTERY LED (Amber) flashes. The following figure shows the basic status of the device display.
[sc_pressEnter_lcd, 1, en_US]
Figure 7-1 Status of Device Display
7.4
Commissioning
7.4 Initial Startup
76 Reyrolle, Operating, Manual
C53000-B7040-C103-1, Edition 10.2022
To Next Page
Loading...
