23/218
Siemens Building Technologies Basic Documentation RVA63.242, RVA53.242 CE1P2373E
Landis & Staefa Division Handling 26.03.2001
2.4 Parameter settings for the end-user
The following settings can be made to meet the individual needs of the end-user.
Buttons Explanation Line
1
Press one of the line selection buttons UP/DOWN.
This will take you directly to the programming mode
"End-user”.
2
Press the line selection buttons to select the required
line.
The parameter list on the next 2 pages contains all
available lines.
• • •
3
Press the + or - button to set the required value.
The setting will be stored as soon as you leave the
programming mode or change to another line.
The parameter list on the next 2 pages contains all
settings that can be made.
4
By pressing any of the operating mode buttons, you
leave the programming mode "End-user”.
• Note:
If no button is pressed for about 8 minutes, the
controller will automatically return to the operating mode
selected last.
Continuous
display
Description
Setting
To Next Page
Loading...
