91/94
Siemens Building Technologies Basic Documentation RVD110, RVD130 CE1P2381E
HVAC Products Revision history 27.05.2004
Revision history
The following changes have been made against edition 3.0:
Chapter / section /
subsection
Change
1.4 Table with documentation revised
3.1 Function block table revised
4 Sensor elements: Landis & Staefa Ni replaced by LG-Ni
5. Title of chapter changed
5.1 Operating line 4 removed, operating lines 6…12 added (relocated)
5.3 New section (relocated)
6.1 Operating lines 5 and 16 added
6.2 Section added
7 Title of chapter changed
7.1 Operating lines 41 and 42 added
7.2 Title of section changed
7.3 Section added
10.1 Operating lines 56, 57 and 58 added
10.2. Title of section changed
10.3 New section (text partly adopted or relocated)
11.1 Operating lines 67 and 68 removed
11.3.2 Second paragraph changed, third paragraph added (adaptation sensitivity removed)
11.10.2 Last sentence added
13.6 Title of section changed
14.1 Operating line 105 setting range added
14.3.1 Subsection added
14.3.2 Release is independent of the plant type
After the table: Release defined; note on valid setpoint
14.3.4 Table: Mode of operation applies to plant types 2…7
14.4.3 Note on legionella function added
15 Entire chapter added
16.4 Setpoint boost: On operating line 116
16.5 Various changes (table, setting range)
18.2.4 Radio receiver removed
18.2.5 Note on RVD110 added
19.1 Operating line 157 added; setting range operating line 163 corrected
19.3.3 Second paragraph added (maximum setpoint during the legionella function)
19.8.2 Setting range and increments changed
20.3.4 QAW70 line 3 changed
Note on Installation Instructions G1637 added
22.1.4 Various changes
23.3.2 Legend B3: ”1” removed
26 Entire chapter added
To Next Page
Loading...
