Siemens S120 - 9 Programming with Keyboard and Menu; Basic Operator Panel Bop20; Description; Interface Description

Siemens S120_EN_rev06-08062017.docx 9-1
9 PROGRAMMING WITH KEYBOARD AND MENU
For simplicity it is preferable to perform the commissioning via PC using the STARTER software,
rather than setting the parameters from the operator panel. See Chapter 8.
9.1 BASIC OPERATOR PANEL BOP20
9.1.1 Description
The Basic Operator Panel BOP20 is an operator panel with six keys and a backlit display unit. The BOP20
can be inserted on the CU310-2 PN SINAMICS Control Units and operated.
The BOP20 supports the following functions:
 Input of parameters and activation of functions
 Display of operating modes, parameters, alarms and faults
9.1.2 Interface description
Figure 49 - Basic Operator Panel BOP20
Overview of displays and keys
Figure 50 - Overview of displays and keys
Table 19 Views
Display
Meaning
Top left 2 positions
The active drive object of the BOP is displayed here.
The displays and key operations always refer to this drive object.
RUN
Is lit (bright) if the displayed drive is in the RUN state (in operation).