Siemens S7-1200 - Reset Module to Factory Settings

SM 1278 4xIO-Link Master
15.1 SM 1278 4xIO-Link Master overview
S7-1200 Programmable controller
818 System Manual, 03/2014, A5E02486680-AG
15.1.6
Reset module to factory settings
Effects of resetting to the factory settings
Use the function "Reset to factory settings" to restore the parameter assignments you made
with S7-PCT to the delivery state.
After a "Reset to factory settings", the parameters of the SM 1278 4xIO-Link module are
assigned as follows:
● The ports are in DI mode
● The ports are mapped to the relative addresses 0.0 to 0.3
● The PortQualifier is disabled
● Maintenance data 1 to 3 is deleted
Note
When you reset to factory settings, the device parameters are deleted and the delivery state
is restored.
If you remove an SM
1278 4xIO-
Link signal module, reset it to factory settings before you put
it into storage.
Procedure
For "Reset to factory settings", proceed as described in the S7-PCT online help under
"Master Configuration > 'Commands' tab".