Siemens S7-1200 - 5 Operating; Start the Application

5 Operating
EtherNet/IP Scanner
Entry-ID: 109782314, V1.1.0, 04/2021
29
© Siemens AG
2021 All rights reserved
5 Operating
5.1 Start the application
The application will be operated by simply toggle the “enable” input parameter of
the LCCF_EnetScanner function block to “TRUE” and monitor the exchanged data.
For this follow the below instructions as a watch table has been prepared in the
application examples TIA Portal project.
Table 5-1:
Ste
p
Instruction
Result
1.
Open the prepared watch table “Watch
EnetScanner”
The watch table opens
2.
Switch the watch table online to be able
to monitor and modify values
The watch table switches online. This is
indicated with an orange title bar.
3.
Modify the “enable” variable to “TRUE”
This can be done either by
typing the value “1” or “TRUE” into the
“Modify value” column
or by using the context menu
as a result, the LCCF_EnetScanner
establishes connections to the
configured adapters and starts the data
exchange.
The status of the LCCF_EnetScanner is
reported as 16#7002, which means
busy. The appropriate flags are set as
well accordingly.