Siemens S7-200 - Viewing the Screens and the Alarms

Operating Your Text Display (TD) Device
5.5 Viewing the Screens and the Alarms
Text Display (TD) User Manual
110 System Manual, 08/2008, A5E00765548-03
'LVSOD\$ODUPV
2SHUDWRU0HQX
'LDJQRVWLF0HQX
5HOHDVH3DVVZRUG
Figure 5-6 Release Password Command
5.5 Viewing the Screens and the Alarms
Viewing the Screens and the Alarms
As described in Chapter 4, you can configure screens and alarms for the TD device. If you
configure both alarms and screens, you also designate which set of messages (screens or
alarms) are the default display mode for the TD device. The default configuration selects the
screens to be the default display.
After power-up or after a period of inactivity (one minute), the TD device returns to the
default display mode. As shown in the figures below, the operator can switch between the
default display mode and the secondary display mode.
Tip
For the TD 100C, TD 200C, and the TD400C: If you do not configure buttons for ESC or
ENTER, you cannot access the main menu.