Using the Keypad Designer to Create a Custom Faceplate for your Text Display (TD) Device
3.5 Defining the Properties of the Button
Text Display (TD) User Manual
54 System Manual, 08/2008, A5E00765548-03
Table 3- 2 Button Properties for the TD 100C, TD 200C, and TD400C
Category Function Description
Enter Selects a menu item or confirms a value
Escape Exits from a menu or cancels a selection
Up Arrow Scrolls (upwards) through menu items or increments a value that can be
edited
Down Arrow Scrolls (downwards) through menu items or decrements a value that can
be edited
Left Arrow Moves the cursor to the left
Navigation or Selection
Right Arrow Moves the cursor to the right
Set Bit Sets a memory bit in the S7-200 CPU. You use the Text Display wizard to
assign the specific bit address
For the TD 200C and TD400C, you can use this button to set two different
bits by defining the Shift button
Shift Allows you to use one Set PLC Bit button to control two different bits in
the S7-200 CPU (TD 200C, TD400C)
Clear Value Sets the value being entered to zero (0)
Entering data
Edit V-Memory Edits a V memory location in the S7-200 CPU. You must specify the
address for the V memory at run time (TD 200C, TD400C)
Menu Mode Displays the standard TD menus (See Chapter 5)
Display Alarm Displays the current alarm message(s)
Display User
Menus
Displays the user menu
Menu 1 Screen 0 Displays the first user screen in the first user menu
Menu 2 Screen 0 Displays the first user screen in the second user menu
Menu 3 Screen 0 Displays the first user screen in the third user menu
Menu 4 Screen 0 Displays the first user screen in the fourth user menu
Menu 5 Screen 0 Displays the first user screen in the fifth user menu (TD 200C, TD400C)
Menu 6 Screen 0 Displays the first user screen in the sixth user menu
(TD 200C, TD400C)
Menu 7 Screen 0 Displays the first user screen in the seventh user menu
(TD 200C, TD400C))
User Screens and Alarms
(User menu or Alarms
menu)
See Chapters 4 and 5
Menu 8 Screen 0 Displays the first user screen in the eighth user menu (TD 200C,
TD400C))
CPU Status Displays the View CPU Status screen
Reads and displays the status of the S7-200
Select Language
Set
Displays the Set Language screen, allowing you to switch between the
languages that you configured for the TD 200C, TD400C)
Setting up the TD 200C
(Operator menu)
See Chapter 5
Set PLC Time and
Date
Displays the Set Time and Date screen, allowing you to enter the time
and date
Change PLC
Mode
Displays the Change CPU Mode screen, allowing you to change the
operating mode of the S7-200 (TD 200C, TD400C)
Edit Memory Displays the Edit CPU Memory screen (TD 200C, TD400C)
Force I/O Displays the Force I/O screen (TD 200C, TD400C)
Program Memory
Cartridge
Displays the Make MC screen, allowing you to copy the user program to
the memory cartridge (TD 200C, TD400C)
Diagnostics
(Diagnostic Menu)
See Chapter 5
TD Setup Displays the TD Setup screen
To Next Page
Loading...
