Using the Keypad Designer to Create a Custom Faceplate for your Text Display (TD) Device
3.11 Installing the Printed Faceplate onto the TD device
Text Display (TD) User Manual
64 System Manual, 08/2008, A5E00765548-03
3.11 Installing the Printed Faceplate onto the TD device
Installing the Printed Faceplate onto the TD 100C, TD 200C, and TD400C
Use the following procedure to install your custom faceplate on the TD device. The example
shown here is for the TD 200C. Installing a faceplate on a TD 100C and TD400C is similar;
the differences are noted below. To prepare for installation, remove the protective film
covering the display window of the TD device and the back of the preprinted (standard)
faceplate. The protective film is blue for the TD 100C and the TD 200C, and transparent for
the TD400C.
1. If your TD device has a strip of protective paper, remove the strip to expose a strip of the
adhesive. For the TD 200C and TD400C, it is on the left side; for the TD 100C, it is on the
right side of the device.
2. Carefully align your custom faceplate on the entire TD device, and then seal the faceplate
to the exposed adhesive by pressing down on the left (TD 200C and TD400C) or on the
right (TD 100C) side of the faceplate.
3. Carefully lift back the unadhered faceplate and remove the rest of the protective paper
from the TD device.
4. Carefully position the faceplate onto the TD device. Firmly press the faceplate onto the
adhesive, taking care to remove any air bubbles that may have been trapped underneath.
NOTICE
Do not use excessive force or a hard (or sharp) tool when you install the faceplate onto
the TD400C device.
If you use excessive force a hard tool when you press the faceplate onto the TD400C
device, it may cause damage to the springs under the faceplate.
Ensure that excessive force or a hard (or sharp) tool is not used when you install the
faceplate onto the device
Refer to Chapter 2 for additional information about installing the TD devices, including the
dimensions for the faceplate.
To Next Page
Loading...
