Siemens S7-200 - Page 88

Using the Text Display Wizard to Configure the S7-200 CPU for Your Text Display (TD) Device
4.5 Configuring the Alarms
Text Display (TD) User Manual
88 System Manual, 08/2008, A5E00765548-03
● Priority for the alarms is determined by the sequence in which you configure the alarms:
– The first alarm has the highest priority
– The last alarm has the lowest priority
● Acknowledgement (if required)
ᅛ
ᅛ
$ODUPV
6HOHFWWKHGLVSOD\RSWLRQV
Ⴠ
 'HILQHWKHVL]HRIWKHDODUPVHLWKHU
RUOLQHV
Ⴠ
'HILQHKRZWRDQQRXQFHWKHDODUP
'HILQHWKHDODUPPHVVDJH
Ⴠ
 'HILQHWKHWH[W
Ⴠ
,QVHUWDYDULDEOHRSWLRQDO
Ⴠ
,QVHUWDQLFRQRSWLRQDO
7'&7'&RQO\
Figure 4-23 Configuring the Alarms
The TD 200, TD 200C, and TD400C devices store up to 80 alarms, and the TD 100C device
stores up to 40 alarms. The TD displays the alarm messages according to priority.
The operator uses the buttons on the keypad to scroll through the list of alarms. See the
figure below.
(QWHU
(6&
$FNQRZOHGJHVWKHDODUP
WKDW\RXKDYHVHOHFWHG
6FUROOVXSWKURXJKWKHOLVWRIDODUP
PHVVDJHVDQGZUDSVWRWKHODVWLWHP
6FUROOVGRZQWKURXJKWKHOLVWRIDODUP
PHVVDJHVDQGZUDSVWRWKHILUVWLWHP
5HWXUQVWRWKH
PDLQPHQX
<RXFDQFRQILJXUHXSWRDODUPVIRU\RXU7'7'&
DQG7'&DQGXSWRDODUPVIRU\RXU7'&
7KHRUGHURIWKHDODUPVLQ\RXUFRQILJXUDWLRQGHWHUPLQHVWKH
SULRULW\
Ⴠ
 7KHILUVWDODUPLQ\RXUFRQILJXUDWLRQKDVWKHKLJKHVWSULRULW\
Ⴠ
7KHVHFRQGDODUPLQ\RXUFRQILJXUDWLRQKDVWKHVHFRQG
KLJKHVWSULRULW\
$ODUPKLJKHVWSULRULW\
$ODUP
$ODUPORZHVWSULRULW\
$ODUP
$ODUP
$ODUP
$ODUP
$ODUP
Figure 4-24 Alarm Messages