Siemens S7-300 - Page 177

Web diagnostics
11.3 Diagnostics pages of the CP
Configuring and commissioning S7 CPs for Industrial Ethernet
Configuration Manual, 09/2013, C79000-G8976-C182-13
177
Rack configuration / subsystem configuration
The components configured in the station rack or in the subsystem are displayed here.
Slots of the station as well as general data and the status of the devices are displayed.
Note
Display topology enabled / disabled
The configurable "Topology display" option influences the displays described below.
•
"Display topology" option enabled
The display is as described below with the additional "Status" and "Identification" tabs.
•
"Display topology" option disabled
Web diagnostics has less information than when the topology display is enabled. The
display is adapted accordingly.
Parameters
Function
Rack configuration (rack name, rack number)
Slot
Slot of the individual modules in the rack
Status Status display of the relevant module:
• Green (OK, module in operation)
• Red (a problem has occurred)
• Yellow (module changed to STOP)
The "Status" tab contains further information.
Module name / name
Name of the module specified in the configuration
Order number
Order number of the module
I address
Configured start address of the module for inputs
Q address
Configured start address of the module for outputs
Topology
The two web pages, "Topology" and "Module information", are linked. A click on "Topology"
of the selected module automatically takes you to this module in the graphic view of the
target topology on the "Topology" Web page. The module appears in the visible area of the
"Topology" web page and the device head of the selected module flashes for a few seconds.