Siemens S7-300 - Page 178

Web diagnostics
11.3 Diagnostics pages of the CP
Configuring and commissioning S7 CPs for Industrial Ethernet
178 Configuration Manual, 09/2013, C79000-G8976-C182-13
"Status" tab
Shows the status and the LED status of the module
Display area
Function
Left Status display of the relevant module:
• Green (OK, module in operation)
• Red (a problem has occurred)
• Yellow (module changed to STOP)
Listing of the LEDs LED display of the module with the following status:
• Gray (inactive LED, the LED is off)
• Colored (active LED, the LED is lit)
The number and type of the LEDs depends on the particular module type. You will find an
explanation of the significance of the LEDs in the documentation for the particular module.
"Identification" Tab
This tab only displays the following module parameters configured offline, no online data of
modules:
● Vendor
● Firmware version
● Device class
● Plant designation
● Location identifier
● Installation date
● Description
PROFINET IO systems
If the connected device is part of a PROFINET IO system, the mode (device/controller),
PROFINET device name, IP address and status information of the device is displayed.
With an IO controller, the connected IO devices are displayed.
With an IO device, the submodules with their status and the IO controller with its status are
displayed.
Note
Shared device
In the case of a shared device, both IO controllers are displayed.
In the table of the submodules, the "IO controller" column shows the IO controller t
o which
the submodule is assigned.