Siemens S7-300 - Industrial Ethernet

Web diagnostics
11.3 Diagnostics pages of the CP
Configuring and commissioning S7 CPs for Industrial Ethernet
Configuration Manual, 09/2013, C79000-G8976-C182-13
179
11.3.5
Industrial Ethernet
The "Industrial Ethernet" entry in the navigation panel provides information on the Ethernet
interfaces.
Interface setting
If the device has several interfaces, the interface number (for example "Interface X1") is
displayed in a drop-down list in the title bar.
Select the required interface from the drop-down list. The setting applies to the "Parameters"
and "Statistics" tabs of the "Industrial Ethernet" entry in the navigation panel.
"Parameter" tab
This page shows you the various parameters of the MAC address, the IP address and the
LAN attachments.
Parameters
Function
Network attachment
MAC address
(active)
Active MAC address of the CP
MAC address (set in
the factory)
MAC address set in the factory
Device name
PROFINET device name configured in STEP 7 (X1 or X2 interface)
IP parameters
IP address
IP address of the CP (or of the interface)
Subnet mask
Configured subnet mask
Default router
IP address of a configured router
Router used
IP address of the router used
IP settings
How the IP address is assigned (for example, STEP 7, DHCP ...)
Physical properties
Port number
Port number of the LAN interface
Link status Status of the LAN port:
• OK
• no link
• disabled
Setting Display of the individual network settings configured in STEP 7:
• Configured
• automatic (automatic setting / autonegotiation)