Siemens S7-300 - Security; Topology

Web diagnostics
11.3 Diagnostics pages of the CP
Configuring and commissioning S7 CPs for Industrial Ethernet
Configuration Manual, 09/2013, C79000-G8976-C182-13
187
11.3.10
Security
The "Security" entry in the navigation panel provides information about the configured
security functions.
Note
Security enabled - navigation panel "IP Access Protection"
The navigation panel "Security" only exists if security is enabled
. If security is disabled, you
can obtain corresponding information from the "IP Access Protection" navigation panel.
Parameters
Function
Project information
Author
Name of the user who last loaded the configuration data.
Date created
Date and time of the last configuration
Project name
Initially configured name of the STEP 7 project.
Last changes
Entries exist here if changes have been made.
Author
Name of the user who made the current change.
Date created
Date and time of the change.
Project name Current name of the STEP 7 project.
Operating modes
Display of the current statuses of the individually listed security functions
Level 2 firewall
Possible operating modes are:
• Not configured
• Configuration was adopted
• Error in configuration
Level 3 firewall
Level 2 VPN
Level 3 VPN
Certificate
Signature check
User management
Logging
11.3.11
Topology
Topology of the PROFINET nodes
The "Topology" Web page provides information about the topological configuration and
status of the PROFINET devices on your PROFINET IO system.
There are three tabs for the following views: