Configuring and commissioning S7 CPs for Industrial Ethernet
Configuration Manual, 09/2013, C79000-G8976-C182-13
241
This section provides an overview of the previous releases of this manual.
This was new in release 10/2012 (C79000-G8900-C182-12)
● Editorial adaptations to the currently available devices and the current versions of the
configuration tools
This was new in release 03/2012 (C79000-G8900-C182-11)
● Editorial revision
Adaptation of the description of the parameter groups to match the configuration in STEP
7 V5.5 and V12.
● Technical innovations / new content
– Industrial Ethernet Security: New advanced CPs
– Expanded Web diagnostics for new CPs: Topology view, update center
– Downloading firmware via the update center in Web diagnostics on newer CPs
This was new in release 07/2010 (C79000-G8900-C182-10)
● Structural innovations in the documentation
The section "Programmed communications connections" is now in the manual./10/
(Page 230)
● Technical innovations / new content
Apart from various adaptations to the currently supplied devices and the current version
of STEP 7 / NCM S7 V5.5, the following features were included:
– The information about unspecified connections relating to S7 connections was
expanded in the section "Configuring communications connections".
– The previous name "S5-compatible communication" has been replaced by the name
"Open communications services".
– The section "CP as Web server: HTML process control" takes into account that S7
applets can only be created by individual use of the supplied S7 beans; the CP does
not provide any pre-programmed specific S7 applets.
To Next Page
Loading...
