Configuring the Ethernet CP with STEP 7
3.3 Setting further CP properties
Configuring and commissioning S7 CPs for Industrial Ethernet
44 Configuration Manual, 09/2013, C79000-G8976-C182-13
Table 3- 2 Object properties of the interface (Ethernet/gigabit and PROFINET)
Parameter group / function
STEP 7 V5.5
Tabs in the "Object
properties" dialog of the
interface
STEP 7 Professional
Parameter group under
"Properties > General"
> ...Interface
Networking Ethernet CP (Page 40)
> Interface networked with
"Port parameters" parameter group (Page 61)
Interface (port properties)
Individual network settings / transmission
> Options > Advanced options
"Options / Settings" parameter group (Page 46)
Communications interrupts
"IP configuration" parameter group (Page 55)
• Configuration of the IP address
setting
• Configuration method for configuring
IP address
> IP configuration > IP protocol
"PROFINET" parameter group (Page 63)
Set properties for PROFINET IO and
PROFINET interface >
PROFINET interface
Configure device as intelligent
PROFINET interface > I
PROFINET interface > I
Configuring synchronization properties of
the device as a PROFINET IO controller
PROFINET interface >
PROFINET interface >
Media redundancy (Page 70)
Configuring the device as a node in a
ring topology with the media redundancy
PROFINET interface >
media redundancy
PROFINET interface >
Advanced options > Media
"General" parameter group
Function of the I&M data
Among other things, in this area, you can configure identification data for modules that
support I&M data (I&M = Identification & Maintenance). These are the plant designation and
the location designation. With the I&M data, for example, standardized identification systems
for devices are supported in the power station sector. Regardless of this, you can use the
I&M data for an additional device identifier you require.
To Next Page
Loading...
