Settings
10.9 Disabling software limit switches
FM 352 electronic cam controller
124 Operating Instructions, 05/2011, A5E01071724-03
10.9 Disabling software limit switches
Definition
Use the "Disable software limit switches" function to disable monitoring of the software limit
switches at a linear axis.
The setting remains active until you deactivate it. This re-enables the originally assigned
software limit switches.
Programming steps
Set the function switch in the channel DB.
Data used in the channel DB
Address Name Type Start value Comment
34.4 SSW_OFF BOOL FALSE 1 = software limit switch disabled
Data used in the parameter DB
Address Name Type Start value Comment
64.0 SSW_STRT DINT L#-1000000000 Software limit switch start
68.0 SSW_END DINT L#1000000000 Software limit switch end
To Next Page
Loading...
