Settings
10.10 Simulating
FM 352 electronic cam controller
Operating Instructions, 05/2011, A5E01071724-03
127
Effects when simulation mode is deactivated
● Cam processing will be disabled.
● The synchronization of an incremental encoder or initiator will be cleared. The actual
value will be reset to the value of the reference point coordinate.
● The module reports the actual position value which corresponds with the absolute
encoder value. The module then evaluates the encoder signals as defined at the machine
parameters.
Limit values
The min./max. simulation velocity depends on the resolution (see chapter "Machine data of
the axis (Page 75)").
Velocity
The module may operate with differences between the online velocity and offline settings
(see chapter "Machine data of the axis (Page 75)").
To Next Page
Loading...
