FM 352 electronic cam controller
Operating Instructions, 05/2011, A5E01071724-03
177
Data blocks / error lists
C
C.1 Content of the channel DB
Note
Do not modify any data not listed in this table.
Content of the channel DB
Address Name Type Initial value Comment
Addresses/ version switch
0.0 MOD_ADDR (enter!) INT 0 Module address
2.0 CH_NO INT 1 Channel number (always 1)
10.0 PARADBNO
INT -1 Number of the parameter DB
-1 = DB not available
12.0 FM_TYPE BOOL FALSE 0 = FM 352 up to V4.0
1 = FM 352 V5.0 or higher
Control signals
15.2 DIR_M BOOL FALSE 1 = simulation in negative direction
15.3 DIR_P BOOL FALSE 1 = simulation in positive direction
15.4 CAM_EN BOOL FALSE 1 = enable cam processing
15.5 CNTC0_EN BOOL FALSE 1 = enable count function of counter cam
track 0
15.6 CNTC1_EN BOOL FALSE 1 = enable count function of counter cam
track 1
16.0 TRACK_EN WORD W#16#0 Enable cam tracks 0 to 15
Bit 0 = track 0
Checkback signals
22.2 DIAG BOOL FALSE 1 = diagnostic buffer changed
22.4 DATA_ERR BOOL FALSE 1 = data error
22.7 PARA BOOL FALSE 1 = module has parameters assigned
23.4 CAM_ACT BOOL FALSE 1 = cam processing busy
To Next Page
Loading...
