Data blocks / error lists
C.1 Content of the channel DB
FM 352 electronic cam controller
180 Operating Instructions, 05/2011, A5E01071724-03
Address Name Type Initial value Comment
Done bits for function switches
40.0 EDGE_D BOOL FALSE 1 = "activate edge detection" or "deactivate
edge detection" completed
40.1 SIM_D BOOL FALSE 1 = "activate simulation" or "deactivate
simulation" completed
40.2 MSR_D BOOL FALSE 1 = "activate length measurement" or
"deactivate length measurement" completed
40.3 REFTR_D BOOL FALSE 1 = "activate retrigger reference point" or
"deactivate retrigger reference point"
completed
40.4 SSW_D BOOL FALSE 1 = "activate software limit switch" or
"Deactivate software limit switch" completed
Done bits for write jobs
41.0 MDWR_D BOOL FALSE 1 = "write machine data" job completed
41.1 MD_D BOOL FALSE 1 = "Activate machine data" job completed
41.2 AVALREM_D BOOL FALSE 1 = "cancel set actual value" or "cancel set
actual value on-the-fly" completed
41.3 CAM1WR_D BOOL FALSE 1 = "write cam data 1" job completed
41.4 CAM2WR_D BOOL FALSE 1 = "write cam data 2" job completed
41.5 CAM3WR_D BOOL FALSE 1 = "write cam data 3" job completed
41.6 CAM4WR_D BOOL FALSE 1 = "write cam data 4" job completed
41.7 CAM5WR_D BOOL FALSE 1 = "write cam data 5" job completed
42.0 CAM6WR_D BOOL FALSE 1 = "write cam data 6" job completed
42.1 CAM7WR_D BOOL FALSE 1 = "write cam data 7" job completed
42.2 CAM8WR_D BOOL FALSE 1 = "write cam data 8" job completed
42.3 REFPT_D BOOL FALSE 1 = "set reference point" job completed
42.4 AVAL_D BOOL FALSE 1 = "set actual value" job completed
42.5 FVAL_D BOOL FALSE 1 = "set actual value on-the-fly" job completed
42.6 ZOFF_D BOOL FALSE 1 = "set zero offset" job completed
42.7 CH01CAM_D BOOL FALSE 1 = "change 1 cam" job completed
43.0 CH16CAM_D BOOL FALSE 1 = "change 16 cams" completed (fast cam
parameter change)
To Next Page
Loading...
