Data blocks / error lists
C.4 Error classes
FM 352 electronic cam controller
Operating Instructions, 05/2011, A5E01071724-03
191
No. Meaning Diagnostic
interrupt
Enable machine data not permitted
20
Cause There are no new (error-free) machine data on the module
No
Set actual value on-the-fly not permitted 21
Cause An attempt was made to execute "set actual value on-the-fly"
while "retrigger reference point" was active.
No
Illegal bit-coded setting 27
Cause Unused and, in this case, unwritten bits are not 0.
An attempt was made to select "length measurement" and
"edge detection" at the same time.
No
Retrigger reference point is not permitted 28
Cause An attempt was made to execute "retrigger reference point"
while "set actual value on-the-fly" was active.
An attempt was made to execute "retrigger reference point"
with an SSI encoder.
No
Illegal bit-coded command 29
Cause Unused and, in this case, unwritten bits are not 0.
No
30 Incorrect lead time No
Incorrect cam number 31
Cause Cam is invalid.
The cam number is not in the range 0 to 127.
No
Incorrect cam start 32
Cause The cam start is outside the traversing range
(-100 m to +100 m or -1000 m to +1000 m).
Rotary axis: The cam start is < 0 or greater than the end of
rotary axis.
No
Incorrect cam end / incorrect activation time 33
Cause The cam end is outside the traversing range
(-100 m to +100 m or -1000 m to +1000 m).
Rotary axis: The cam end is < 0 or greater than the end of
rotary axis.
The cam is not active at least for the duration of one pulse.
With an inverse cam, there are not at least 4 pulses between
the cam start and cam end.
No
Cancel set actual value not possible 34
Cause The actual position value would be outside the operating range
with an SSI encoder and linear axis after making the setting.
No
To Next Page
Loading...
