Siemens S7-300 - D.12 Parameter Transfer Routes

Programming without SFB 52 and SFB 53
D.12 Parameter transfer routes
FM 352 electronic cam controller
218 Operating Instructions, 05/2011, A5E01071724-03
Some use cases for the transfer of parameters
Use case Steps
You edit the parameters on the parameter assignment interface.
The parameters should then be assigned automatically to the
module during startup.
Perform steps 1, 2, and 3.
You modify parameters for commissioning in test mode in the
parameter assignment interface:
Perform steps 4 and 5
The parameters modified during commissioning should be
downloaded automatically during startup.
Perform steps 1, 2, and 3.
You create the parameters using the parameter assignment
interface. When it starts up, the module should be assigned
parameters only by the user program via data blocks.
Perform steps 10 and 6.
You want to create convenient data sets for recipes. Perform step 10.
You create the parameters using the parameter assignment
interface. These should be available to the user program for
temporary modifications.
Perform steps 1, 2, and 3 for
automatic parameter
assignment. Perform steps 10,
7 to enable access by the user
program.
You modify existing parameters (exclusively) using the user
program.
Perform steps 7, 9, 8, and 6.
You want to view the data modified by the user program on the
parameter assignment interface.
Perform step 11.
Parameters modified by the user program should also be loaded
automatically during startup.
Perform steps 6, 11, 1, 2, and
3.