Programming the FM 352
7.11 Parameter transmission paths
FM 352 electronic cam controller
Operating Instructions, 05/2011, A5E01071724-03
59
Some use cases for the transfer of parameters
Use case Steps
You edit the parameters on the parameter assignment interface.
The parameter should then be assigned automatically to the
module during startup.
Perform steps 1, 2, and 3.
You edit parameters on the parameter assignment interface in the
commissioning test mode:
Perform steps 4 and 5
The parameters edited during commissioning should be
downloaded automatically during startup.
Perform steps 1, 2, and 3.
Create the parameters using the parameter assignment interface.
When it starts up, the module should be assigned parameters only
by the user program using data blocks.
Perform steps 10 and 6.
You need a comfortable means of creating data records for recipes. Perform step 10.
Create the parameters using the parameter assignment interface.
These should be available to the user program for temporary
modifications.
Perform steps 1, 2, and 3 for
automatic parameter
assignment. Perform steps 10,
7 to enable access by the user
program.
You modify existing parameters (exclusively) using the user
program.
Perform steps 7, 9, 8, and 6.
You want to view the data modified by the user program on the
parameter assignment interface.
Perform step 11.
Parameters modified by the user program should also be loaded
automatically during startup.
Perform steps 6, 11, 1, 2, and
3.
To Next Page
Loading...
