Siemens SENTRON 3WA1 - Page 562

Appendix
A.4 ETU600 menu structure
3WA1 air circuit breaker
560 Equipment Manual, 02/2023, 92310000002-06
Active protection parameters
In these menus, the parameters currently used by the ETU600 electronic trip unit for
protection are displayed.
Content
Menu number
Active protection parameters
2.0
L: Long time LT
2.1
L: Long time LT, neutral conductor
2.2
S: Short time ST
2.3
S: Directional short time dST
2.4
I: Instantaneous INST
2.5
G: Ground fault GF Residual
2.6
G: Ground fault GF Direct
2.7
G: Ground fault GF Dual
2.8
G: Ground fault GF Hi-Z
2.9
Reverse power RP
2.11
GF alarm
2.12
DAS+ Dynamic Arc-Flash Sentry
2.13
Zone-selective interlocking ZSI
2.14
Enhanced protective functions EPF
2.15
Change protection parameters
The parameters available for the two parameter sets A and B (option) are listed in
Chapter 2.4.6 "Protection parameters".
Content
Menu number
Change protection parameters
3.0
Parameter set A
3.1
Parameter set B
3.2
DAS+ Dynamic Arc-Flash Sentry
3.3
Zone-selective interlocking ZSI
3.4
Enhanced protective functions EPF
3.5
Status and maintenance
Information about the status and any required maintenance of the circuit breaker is
provided in these menus.
Content
Menu number
Status and maintenance
4.0
Trip log
4.1
Operating hours
4.2
Operating cycles
4.3
Inspection
4.4
Maintenance
4.5
Reset INFO
4.6