Commissioning
6.3 Parameterizing the device
PAC2200
66 Equipment Manual, 12/2019, L1V30415167B-03
Parameterizing the device
The parameters are entered and changed in offline mode.
To switch between online and offline mode, click "Activate online view" in the "Options"
menu or press the "F12" key.
Set the required basic parameters.
Note the description of the parameters in chapter Parameterizing via the device menu
(Page 68).
Make use of the Online Help in powerconfig.
In order to load the parameters to the device, proceed as follows:
1. Integrate the device in powerconfig.
2. In menu item "Views", select the sub-menu "Parameters" or alternatively press the "Ctrl"
and "Pos1" buttons simultaneously.
The "Parameter" window is displayed.
3. In the "Parameters" window, click on the "Load to PC" button.
The set parameters are loaded to the device.
4. Check the device parameters and adjust them if necessary. The parameters can only be
changed in offline mode.
More detailed information on parameterization can be found in the powerconfig Online
Help or in chapter Parameterizing via the device menu (Page 68).
5. In the "Parameters" window, click on the "Load to device" button.
The set parameters are loaded to the device.
"Security" parameter
Activate security with powerconfig:
1. In menu item "Views", select the sub-menu "Security".
The "Security" window is displayed.
2. In the menu item "Options", select "Activate online view".
The "Security" window is refreshed. The following degrees of protection can be
activated/deactivated
– Password protection
– Hardware write-protection
– Subnet firewall protection (IP filter)
"Password protection" parameter
When using password information, write access is possible by means of the "powerconfig"
software.
The password is only required when the "Password protection" parameter is activated.
To Next Page
Loading...
