Siemens SENTRON 7KM PAC2200 - Service and Maintenance; Device Cleaning Instructions; Device Calibration Information; Firmware Update Procedure

Commissioning
6.3 Parameterizing the device
PAC2200
Equipment Manual, 12/2019, L1V30415167B-03
77
"Reset" parameter
Selection
Range
Factory
setting
FACTORY SETTINGS All device settings and measured values except the
communication parameters and energy secondary
values are reset to the as-delivered condition.
No:
 Not active
Yes:
 Active
No
COMMUNICATION PARAMETERS All communication settings are reset to the as-
delivered condition.
No:
 Not active
Yes:
 Active
No
Confirmation of the reset
Confirmation of the reset
0000
Note
The reset must be confirmed by selecting the "Execute..." field. Otherwise the device reset is
not executed.