Installation and connection
4.3 Connecting the devices
Circuit protection devices with communication and metering function
System Manual, 06/2021, L1V30827018B-01
31
To remove the cable, press on the slot of the terminal release with a 0.4 x 2.5 mm
screwdriver, then the cables can be easily pulled out.
For the data transceiver, the Ethernet cable (min. Cat5 F/UTP) must also be connected in
addition to the supply voltage after the dummy plug has been removed. If only one Bluetooth
connection is required, the dummy plug should remain in the device to protect the device
from external influences.
To Next Page
Loading...
