Description
3.3 Single-phase devices
7KT16 energy meter
Equipment Manual, 09/2020, 2514284147-04
21
3.3.3 Selection of measured values
Press the front key briefly to select the displayed values on the screen in the sequence shown
below.
Each measured variable is indicated by the corresponding symbol in the lower section of the
display.
One minute after you last pressed the key, the display automatically switches to the screen
for total active energy.
1)
Partial hour counter (hhhh.mm)
2)
15 min power demand values
2)
The measurements are only displayed if parameter P-08 is activated
2)
The measurements are only displayed if parameter P-09 is activated
3.3.4 Parameterization
Note
Follow the menu operation when setting the parameters. You can find more information on
this in chapter Keypad functions (Page 19).
To Next Page
Loading...
