Siemens SENTRON PAC3200 - 8.2 Operator input steps

Operator control
8.2 Operator input steps
SENTRON PAC3200
Manual, 02/2008, A5E01168664B-04
117
Function keys
Table 8-4 Assignments of the function keys in edit mode of the device settings
Key function F1 F2 F3 F4
Reject the changes and return to display
mode
Increment the numerical value by "1"
or
show the next selectable setting
Decrement the numerical value by "1"
Go to the next digit to the right in the multi-
digit numerical value
Save the changes and return to display
mode
See also
Display of the device settings (Page 115)
8.2 Operator input steps
8.2.1 Operator input steps in the measured variable display
Selecting the measured variable
When displaying the instantaneous value, it is possible to switch to other measured
variables.
F2
switches to the previous measured variable.
F3
switches to the next measured variable.
The order of the measured variables corresponds to the order in the main menu.
If the maximum/minimum value or average value is displayed, F2
and F3 are not
available. In this case, switch first to the display of the instantaneous value.
Note: It is also possible to select the measured variable in the main menu.
Display the instantaneous, maximum/minimum or average value
F1 switches the display on.
F1
: Display of the maximum value
F1
: Display of the minimum value
F1
: Display of the instantaneous value
F1
: Display of the average value