Siemens SENTRON PAC3200 - Communication

Parameterize
9.2 Parameterizing the operator interface
SENTRON PAC3200
140 Manual, 02/2008, A5E01168664B-04
9.2.7 Communication
Device address:
● MAC address
● TCP/IP addresses
Figure 9-13 "COMMUNICATION" device setting
A change to the TCP/IP addresses only becomes effective after the device has been
restarted.
If you exit the "COMMUNICATION" device setting with the F1 key
, the device asks if
you want to restart.
● F1 key
: Do not execute a restart. Address changes are saved on the device but do
not become effective.
● F4 key
: Execute a restart. Address changes become effective.
Device settings for communication
MAC-ADDR: MAC address. Read only.
IP-ADDR.: IP address.
SUBNET: Subnet mask.
GATEWAY: Gateway address.
PROTOCOL: SEAbus TCP or MODBUS TCP