Operator control
8.1 Device interface
SENTRON PAC4200
110 Manual, 09/2008, A5E02316180B-01
Function keys
Table 8- 3 Assignments of the function keys in the device settings display
Key function F1 F2 F3 F4
Return to the menu selection
Scroll up in the selection list
Scroll down in the selection list
Change to edit mode
Switch the setting ON/OFF
Return to the menu selection
F4 switches edit mode on. The device settings can be changed in edit mode.
F4
is an ON/OFF switch. The change takes effect immediately. Calling edit mode is no
longer applicable.
F4
is available when the device setting is displayed but cannot be edited. Like F1, F4
returns to the "SETTINGS" menu from this display.
See also
Operator input steps in device settings display (Page 114)
Edit mode of the device settings (Page 110)
8.1.6 Edit mode of the device settings
To edit the device settings, it is necessary to call edit mode. In display mode, the function for
calling edit mode is assigned to F4
.
You can recognize edit mode because the selection bar reduces to the width of the selected
value.
D
Figure 8-12 Edit mode of the device settings
(1) Group title
(2) List of device settings
a) Device setting in edit mode
To Next Page
Loading...
