Parameterizing
9.2 Parameterizing the operator interface
SENTRON PAC4200
Manual, 09/2008, A5E02316180B-01
127
AUTO US Time change within the USA
Changeover to daylight saving time: The
internal clock is put forward from 2 a.m.
local time to 3 a.m. on the second
Sunday in March.
Changeover to standard time: The
internal clock is put back from 2 a.m.
local time to 1 a.m. on the first Sunday in
November.
TABLE Time change can be individually
parameterized. The parameters can be
set in the software.
Default value: AUTO EU
9.2.7 Integrated I/Os
Device settings for using the digital inputs and outputs.
Call: "SETTINGS > INTEGRATED I/O".
DIGITAL OUTPUT
Figure 9-6 "DIGITAL OUTPUT" device settings
DIG.OUTPUT Digital output
Range:
0.0 Digital output DO0 (terminal labeling)
0.1 Digital output DO1 (terminal labeling)
Default value: 0.0
ACTION Method of using the digital output:
Range:
OFF The digital output is switched off.
DEVICE ON The digital output is switched on.
REMOTE OUTPUT The digital output is controlled by remote
access, e.g. SEAbus, SEAbus TCP,
PROFIBUS DP, Modbus RTU,
Modbus TCP.
To Next Page
Loading...
