Parameterizing
9.2 Parameterizing the operator interface
SENTRON PAC4200
Manual, 09/2008, A5E02316180B-01
141
NOTICE
Access protection is switched off
Resetting to the factory defaults deactivates device protection. Password protection is
switched off. The password is set to the value "0000".
NOTICE
Counter reset
Resetting to the factory defaults causes all counters to be reset as well!
COMMUNICATION PARAM. Resets the entered TCP/IP address to:
0.0.0.0
EXECUTE Reset function. Resets the selected value
groups.
9.2.11 External modules
Device settings for expansion modules operated with SENTRON PAC4200.
Call: "SETTINGS > EXTERNAL MODULES".
EXT.MODULES
The "EXT.MODULE" screen lists the expansion modules connected to the "MOD1" and
"MOD2" slots on SENTRON PAC4200, e.g. a PAC PROFIBUS DP or PAC RS485
expansion module.
The operating parameters of the expansion modules, e.g. protocols or addresses, can be set
on the display.
You can find information about the operating parameters of the expansion modules in the
related documentation.
9.2.12 Password management
Default password
The default password is: 0000
If no user-specific password has been assigned, the default password must be entered when
password protection is switched on.
To Next Page
Loading...
