Siemens SENTRON PAC4200 - Structure - Digital Inputs Status and Digital Outputs Status with the Function Codes 0 X01 and 0 X02; Table A- 3 Structure - Digital Inputs Status and Digital Outputs Status; A.3.2 Structure - Digital Inputs Status and Digital Outputs Status with the Function Codes 0 X01 and 0 X02

Appendix
A.3 MODBUS
SENTRON PAC4200
Manual, 09/2008, A5E02316180B-01
203
A.3.2 Structure - Digital inputs status and digital outputs status with the function codes
0x01 and 0x02
The following are available via MODBUS:
● "Digital Inputs Status"
● "Digital Outputs Status"
Input status and output status of the SENTRON PAC Power Monitoring Device
You can use the function codes 0x05 and 0x0F on the digital outputs in addition to the
function codes 0x01 and 0x02.
Table A- 3 Structure - Digital Inputs Status and Digital Outputs Status
Name Length Status Byte Bit Bit mask Access
Digital Outputs Status 32 bits DO 0.0 3 0 0x00000001 R
Digital Outputs Status 32 bits DO 0.1 3 1 0x00000010 R
Digital Inputs Status 32 bits DI 0.0 3 0 0x00000001 R
Digital Inputs Status 32 bits DI 0.1 3 1 0x00000010 R
See also
Measured variables without a time stamp with the function codes 0x03 and 0x04 (Page 196)