SENTRON PAC4200
Manual, 09/2008, A5E02316180B-01
55
Operation planning
4
4.1 Operation planning
Mounting location
The SENTRON PAC4200 device is intended for installation in permanently installed
switching panels within closed rooms.
DANGER
The device is only allowed to be operated at a safe location!
Failure to do so will cause death, serious injury, or property damage.
SENTRON PAC4200 is only allowed to be operated if it is installed in a lockable control
cabinet or a lockable room. Only qualified personnel should have access to this cabinet or
room.
Conductive panels and doors on control cabinets must be grounded. The doors of the control
cabinet must be connected to the control cabinet using a grounding cable.
Mounting position
The device must be installed vertically.
s
r
r
Figure 4-1 Mounting position
The preferred direction of viewing is from below at an angle.
Installation space and ventilation
Sufficient clearance must be maintained between the device and neighboring components in
order to comply with the permissible operating temperature. You can find dimension
specifications in the "Dimension drawings" chapter.
Plan additional space for:
● Ventilation
● Wiring
To Next Page
Loading...
