Installation
5.2 Insert battery
SENTRON PAC4200
Manual, 09/2008, A5E02316180B-01
59
Procedure
1. Discharge any static from your body. Observe the ESD guidelines in the Appendix.
CAUTION
Electrostatic sensitive devices
Discharge your body of any static electricity! Touch the grounded control cabinet, for
example, or a metal part that is connected to the building ground (heater, steel support).
2. Remove the battery from the SENTRON PAC4200 delivery carton.
NOTICE
Reduced service life of the battery
Grease or dirt on the contacts forms a transfer resistance that reduces the service life of
the battery.
Hold the battery by the edges only.
3. Take note of the polarity indicated at the insertion opening of the battery compartment.
Insert the battery into the battery compartment.
Note
Polarity of the battery
The opening of the battery compartment has the same shape as the battery. This
determines the alignment of the terminals. It is not possible to insert the battery
incorrectly.
Figure 5-1 Using the battery
See also
Technical data (Page 153)
To Next Page
Loading...
