Siemens SICAM 7KG85X - Energy Freeze; Function Description; Configuration and Value View Via Web Pages

Energy Freeze
Function Description
The function of Energy Freeze is used to configure the freezing interval for the energy values. After a time
interval is configured, the energy values are frozen and not updated during the interval until the next interval
starts. The frozen values are transmitted by the report function and the IEC 61850 protocol in the MMTN/
MMTR logic node.
Configuration and Value View via Web Pages
Configuration of the Energy Freeze
To change the settings of the energy freeze and reset in the Configuration tab, proceed as follows:
•
In the navigation window, click Energy freeze .
[2021-11-30_144306, 1, en_US]
Figure 5-7 Configuration Tab, Energy Freeze
•
Configure the respective parameters according to the following table.
Table 5-4
Settings for Energy Freeze
Parameter Default Setting Setting Range
Interval 10 min 10 min, 15 min, 30 min, 60 min
•
After the parameterization, click Send.
•
In the navigation window, click Activation and cancel.
•
Enter the activation password (refer to Table 2-3).
•
Click Activation.
Value View of the Frozen Energy
To display the values of the frozen energy in the Value view tab, proceed as follows:
•
In the navigation window, click Frozen energy.
5.2
5.2.1
5.2.2
Energy Management
5.2 Energy Freeze
108 SICAM, SICAM P850/P855 7KG85X, Manual
E50417-H1040-C482-A9, Edition 03.2022