Operation via Display
General Operating Instructions
A restricted operation via the display of the device is possible with the softkeys.
The front softkeys F1 to F4 are used to set parameters, select measurands, and enter various settings.
The following table lists the icons which appear on the display when the softkeys are pressed.
Table 9-3 Control Functions of the Softkeys
Softkey Functions F1 F2 F3 F4
General Softkey Functions
Displaying the RMS value
Canceling an action and returning to the action
displayed previously
Displaying the maximum value
Displaying the minimum value
Scrolling up
Scrolling down
Menu selection
Acknowledging the selection
Special Softkey Functions
Displaying the table of the value
Displaying the graph
Displaying additional information
Active energy supply
Active energy consumption
Inductive reactive energy
Capacitive reactive energy
Scrolling left
Scrolling right
Displaying the next additional information
Switching to edit mode
9.10
9.10.1
Commissioning and First Steps
9.10 Operation via Display
SICAM, SICAM P850/P855 7KG85X, Manual 211
E50417-H1040-C482-A9, Edition 03.2022
To Next Page
Loading...
