LED Indications
Table 10-1 Meaning of LEDs
LED Description
LED is off.
LED is on.
LED is flashing (0.2 s on, 0.2 s off).
LEDs according to configuration
If an indication is assigned to an LED (see chapter 13.3.1.2 LEDs):
•
Indication off → LED off
•
Indication on → LED on
•
Indication invalid → LED is flashing (0.5 s on and 0.5 s off)
Table 10-2 Indication of LEDs
LED Combination Description
No Operation
Device is switched off.
Device is switched on, but firmware is not loaded
or
Device is in startup phase.
Normal Operation
The device uses the IP address configured by the user or received via DHCP.
Normal operation with default IP address
Default IP address is requested by pressing the F4 softkey during normal
operation.
Double IP address has been detected in the network.
The device is in operation but cannot be reached via Ethernet.
Solve this network configuration issue and restart the device.
Each device must have a unique IP address.
An IP address request via DHCP is in progress.
ERR = off and H1 to LEDs according to configuration
RUN LED stops flashing when IP address is received.
Fallback Mode
The device uses the IP address configured by the user or received via DHCP.
The device runs into the Fallback mode after an unresolvable error in
normal operation occurs or by pressing the F4 softkey during device startup.
Fallback mode with default IP address
Default IP address is requested by pressing the F4 softkey during fallback
mode.
10.1.3
Troubleshooting, Repair, and Fallback Mode
10.1 Failures and LED Displays
SICAM, SICAM P850/P855 7KG85X, Manual 235
E50417-H1040-C482-A9, Edition 03.2022
To Next Page
Loading...
