Activation and Cancel of the Configuration Change
When you have changed the configuration via Web pages, you must either enable it as the active set of
parameters or cancel it.
NOTE
If you have finished the configuration, click Send in the respective dialog.
Activating the Set of Parameters
To activate the configuration change in the Configuration tab, proceed as follows:
•
In the navigation window, click Activation and cancel.
[sc_activation_p85x, 1, en_US]
Figure 2-1 Configuration Tab, Activation
•
Enter the activation password (refer to Table 2-3).
•
Click Activation.
If the configuration causes the device to restart, reconnect to the device after the restart.
The modified set of parameters is loaded as the active set of parameters into the device and the new
parameters take effect immediately.
The active and passive set of parameters are listed in the Activation window in the Set column for your
information.
NOTE
Keep the device powered on for at least 30 s after clicking Activation.
NOTE
During the parameter activation, the device is working under special mode. If one kind of recording
happens during this period of time, the integrity of the recorded data cannot be guaranteed.
2.1
Basic Functions
2.1 Activation and Cancel of the Configuration Change
30 SICAM, SICAM P850/P855 7KG85X, Manual
E50417-H1040-C482-A9, Edition 03.2022
To Next Page
Loading...
