Siemens SICAM 7KG85X - Page 98

Parameter Default Setting Setting Range
Logic operation NONE NONE
OR
AND
Group indication name Group Indication x
(x = 1 to 4)
The name of the indication is customizable;
max. 31 characters.
•
After the parameterization, click Send.
•
In the navigation window, click Activation and cancel.
•
Enter the activation password (refer to Table 2-3).
•
Click Activation.
i
i
NOTE
Sources are assigned inside a group indication sequentially from source 1 to source 4.
If you select -none- at the 1st source in a group indication, you cannot configure further sources in this
group indication. In this case, the group indication is inactive.
You can also integrate group indications into subordinated group indications, for example group indica-
tion 1 into group indication 3.
Value View of the Group Indications
To display the values of group indications in the Value view tab, proceed as follows:
•
In the navigation window, click Group indications.
[sc_Group_indication_evaluation, 2, en_US]
Figure 4-8 Value View Tab, Group Indications
Automation Functions
4.2 Group Indications
SICAM, SICAM P850/P855 7KG85X, Manual 97
E50417-H1040-C482-A9, Edition 03.2022