Siemens SICAM CMIC - Binary Information Output; Current;Voltage Output

Engineering via SICAM WEB
220 SICAM RTUs, User Manual SICAM CMIC
DC8-001-2.09, Edition 08.2016
5.1.9.5.6 Binary Information Output
For the output of binary information a digital output module must be equipped, and the DO
signals to be used must be configured.
With the parameter Fail_behav you can determine the behavior of a binary information
output upon failure of the master control element. You find further information thereto in the
manual SICAM RTUs Common Functions Peripheral Elements According to IEC 60870-5-
101/104, chapter "Binary Information Output", section "Deactivation or Retention on Failure".
5.1.9.5.7 Current/Voltage Output
For the output of currents or Voltages an analog output module must be equipped, and the AO
signals to be used must be configured.
With the parameter Fail_behav you can determine the behavior of a binary information
output upon failure of the master control element. You find further information thereto in the
manual SICAM RTUs Common Functions Peripheral Elements According to IEC 60870-5-
101/104, chapter "Binary Information Output", section "Deactivation or Retention on Failure".