5
5.9 Memory Management
111Power Meter SICAM P 7KG7750/55, Manual
E50417-B1076-C340-A6, Edition 09.2013
5. Also, you must indicate the Averaging interval (5 s, 10 s, 15 s, 30 s, 1 min, 5 min, 10 min,
15 min, 30 min, 60 min) and the Storage interval (5 s, 10 s, 15 s, 30 s, 1 min, 5 min, 10 min,
15 min, 30 min, 60 min). These parameters set the number of measured values to be used
for mean value calculation and the interval for saving the values.
5.9.3 Power Values
In this dialog window you can specify the settings for power recording.
Proceed as follows:
1. Select up to eight Measured values and Test points.
2. Select a Date or one of the six Limit value groups as Start selector for the power recording.
It is possible to combine Date and Limit value group as start selectors. The first of the two
criteria fulfilled, will launch the recording.
3. When entering a date as Start selector, you must indicate a year between 2000 and 2060.
Note
If you have entered a past start date, SICAM P will initiate mean value recording immediately
after the setting. Manual start is not activated by configuration but can be initiated at any time.
Note
If the device provides additional analog inputs (optional), you can record external measurement
signals.
To Next Page
Loading...
