5
5.12 Reading the Device Memory
121Power Meter SICAM P 7KG7750/55, Manual
E50417-B1076-C340-A6, Edition 09.2013
5.12 Reading the Device Memory
SICAM P Parameterization allows you read the memory content. The available memory capacity
(1 MByte) can be allocated by the user to the available functions (see chapter 5.9.1).
1. From the menu bar, select Device → Read Memory to select the memory area in the Read
memory dialog
2. Select a memory area.
5.12.1 Handling
Cancel
Click this button to interrupt the data download from the device. If a large amount of the memory
is assigned to a record, the download of data may take a few minutes (at low baud rates perhaps
some hours). The download progress is shown in the status line. If the download was successful
or interrupted by the user, this button will be renamed to Reload.
Reload
Click this button to reload measured values or data from the device.
Note
Depending on the function you have selected, different buttons are displayed. Inactive buttons
are not shown.
To Next Page
Loading...
