1
1.6 Interface and Terminals
30 Power Meter SICAM P 7KG7750/55, Manual
E50417-B1076-C340-A6, Edition 09.2013
1.6.5 Mounting
To mount the device proceed as follows:
• Swing the mounting element (provided with the device) over the rear cone.
• Move the mounting element to the position. Use a screw driver (0.6 x 4.5) mm to fix the moun-
ting elements until the slipping clutch takes effect.
Fig. 1-9 Mounting
WARNING
Warning about dangerous voltages when operating an electrical device.
Nonobservance of the safety instructions means that death, severe
injuries or considerable material damages can occur.
• The SICAM P is a build-in device and must therefore be in-stalled on a switchboard or in a
control cabinet. After installation, it is important that all terminals are properly covered to pre-
vent accidental contact with energized parts.
Notes
• The device location should be largely free from vibrations.
• The device must be operated within allowable ambient temperature limits. Operating the
device outside of the operating temperature range can lead to measurement errors and
device failure.
• Steps should be taken to minimize exposure of the device to direct sun light and large tem-
perature variations.
• Minimum thickness of the mounting plate: 1 mm; steel.
• Steps must be taken to prevent condensation on or within the device during operation.
• To prevent accidental contact with energized parts the above described mounting must be
taken care-fully and correctly.
To Next Page
Loading...
