4
4.4 Basic Settings
65Power Meter SICAM P 7KG7750/55, Manual
E50417-B1076-C340-A6, Edition 09.2013
4.4.3.1 Screen for Energy Pulses
Energy
Selection of an energy or other metered quantity from the table 3-1 (depends on the type of the
input connection).
Value
Selection of the amount of energy required to generate a pulse.
Puls length
Can be selected from 50 ms, 100 ms, 150 ms, 200 ms to 500 ms
.
4.4.3.2 Screen for Limit Values
The values entered for hysteresis, pulse length and filter time are valid for all logically connected
measured quantities.
Hysteresis
• Input of 0.1 % to 10 % of rated value
• Percentage refers to nominal values
energy pulses
*energy: WpL1 d
*value: 0.0088kWh/Imp
*pulse length:200ms
<ok
<cancel
Note
An explanation on power metering can be found in chapter 5.7.2.
limit value
*hysteresis: 1.0%
*pulse length: 1 s
*filter time: 1.0s
>further settings
<ok
<cancel
To Next Page
Loading...
