Siemens SICAM P 7KG7750 - Basic Settings

5
5.5 Basic Settings
86 Power Meter SICAM P 7KG7750/55, Manual
E50417-B1076-C340-A6, Edition 09.2013
5.5 Basic Settings
This dialog allows you to set the network type, the measuring range and the transformer ratio
(optionally).
5.5.1 Connection / Transformer
In order to adapt the SICAM P to the network to be measured, enter the network properties and
the parameters for the current and voltage measurement inputs.
Network type
Select the relevant network type.
• Single-phase
• Three-wire three-phase balanced
• Three-wire three-phase unbalanced (2 current inputs ' Aron circuit)
• Three-wire three-phase unbalanced (3 current inputs)
• Three-phase four-wire balanced
• Three-phase four-wire, unbalanced