5
5.7 Input / Output Modules
96 Power Meter SICAM P 7KG7750/55, Manual
E50417-B1076-C340-A6, Edition 09.2013
5.7.3 Basic Settings
This dialog allows you to specify the I/O module (optionally) of your SICAM P.
There are two possibilities:
SICAM P is connected with PC (online)
1. Click the button Load slot configuration from device. The information will be loaded from
the device and displayed on the screen.
2. Parameterize the I/O modules.
3. Send the new configuration to the device.
A parameter set is prepared for a later transmission to a SICAM P (offline).
1. Define slot A for the corresponding I/O module.
Note
To ensure proper energy registration, this value must not be lower than the value calculated in
step 4.
Note
This procedure ensures that the I/O modules displayed on the screen correspond to those in the
device.
Note
These settings must correspond to the I/O modules in the device (refer to the ordering number,
see chapter 1.3)!
To Next Page
Loading...
